What does each heating repair cost in Orlando?
Here is the full price table — our published Orlando ranges for electric heat, heat pumps and gas furnaces. Most companies won't publish this. We do.
| Repair | Orlando Price Range | System Type | Turnaround |
|---|---|---|---|
| Diagnostic | $89 flat, 24/7, credited to repair | All | Same-day |
| Heat-strip / heat kit replacement | $350–$700 | Heat pump & electric air handler | Same-day |
| Sequencer / relay | $150–$350 | Electric heat | Same-day |
| Contactor | $150–$350 | Heat pump | Same-day |
| Thermostat | $180–$500 | All | Same-day |
| Wiring / low-voltage repair | $150–$350 | All | Same-day |
| Blower motor | $450–$900 | All | Same-day to 2 days |
| Control board | $400–$800 | All | 1–2 days |
| Igniter, flame sensor or limit switch | $150–$400 | Gas furnace | Same-day |
| Condensing furnace drain clearing | $150–$250 | Gas furnace (high-efficiency) | Same-day |
| Defrost control board | $400–$800 | Heat pump | 1–2 days |
| Heating tune-up | $89 | All | Same-day |
About 9 in 10 Orlando homes heat with a heat pump or electric strips in an air handler, not a gas furnace. If you have a heat pump, the full heat-pump-specific list — defrost boards, reversing valves — is on our heat pump repair cost page. Every repair starts with our $89 diagnostic — flat rate, 24/7, credited toward your repair. Need heat today? Book same-day heating repair in Orlando.
Why did my electric heat strips fail — and what does it cost?
They sat idle from April to November. The first cold morning is the first test, and that's when a weak element, sequencer or limit lets go.
Four failure modes: a burned-out element, a failed sequencer (the relay that staggers the strips on), a tripped or failed limit switch, and corroded terminals on the 240 V connections. Heat kit $350–$700; sequencer $150–$350; limit or wiring $150–$350. If the strips are stuck on rather than off, you'll find out on the power bill — see emergency heat and bill spikes.
How much does a gas furnace repair cost in Orlando?
Igniter, flame sensor, pressure switch or limit: $150–$400. Board $400–$800. Blower $450–$900.
Gas furnaces are the minority in Central Florida but they fail the same way everywhere: a dirty flame sensor that drops the burner after three seconds, a cracked hot-surface igniter, a pressure switch that won't prove draft. All same-day. The one repair we won't do is a cracked heat exchanger — that's a carbon-monoxide risk and the furnace gets replaced. See heating installation in Orlando.
That's why heating failures are almost always a part that sat unused — not a part that wore out. It's also why a $89 heating tune-up in November catches most of them before the first cold night.
Why do heating repair quotes vary so much between Orlando companies?
Three reasons: cold-snap surcharges, commission-based pricing, and diagnostic fees that aren't credited to the repair.
The two or three nights a year Orlando drops below 40°F are when every company's phone rings — and when after-hours and "emergency" fees of $50–$150 appear. Technicians paid on repair size quote bigger. And a "free" diagnostic is recovered inside the repair price. Smart Home Air & Heat: flat $89 any hour, no sales quotas, price shown before work starts. Compare with our AC repair cost table — same rules year-round.
When is a heating repair not worth paying for?
Use the $5,000 rule: repair cost × system age. Over $5,000, replace. Under, repair.
Because Orlando heating runs so few hours, an old heat pump's heating failure is usually a symptom of a system that will fail in June too. An $800 board on a 12-year-old system scores $9,600 — get the replacement quote in the same visit. A $300 sequencer on a 6-year-old system scores $1,800 — fix it. Installed prices: heat pump cost in Orlando. The math: repair vs. replace.
What hidden fees should Orlando homeowners watch for?
Four: cold-snap surcharges, uncredited diagnostics, "emergency" trip fees, and free-tune-up bait.
- Cold-snap surcharges — $50–$150 added the week it's cold. Ask before booking.
- Uncredited diagnostics — the trip fee should come off your repair total.
- "Emergency" trip fees — a second fee for the same visit.
- "Free" tune-ups — often a sales visit designed to find $1,000+ of "urgent" work. Ours is $89 with the checklist published.
Heating repair cost questions, answered
How much does it cost to fix a heater that won't turn on?
Usually $150–$700 in Orlando — a thermostat, relay, sequencer or heat-strip kit. A failed control board is $400–$800.
How much is heat strip replacement?
$350–$700 installed. The heat kit is the electric element pack inside your air handler; the price rises with kilowatt rating.
Is the $89 diagnostic applied to my repair?
Yes. Approve the repair and it comes off the total. You only pay $89 by itself if you decline the work.
Do you repair gas furnaces in Orlando?
Yes. Igniters, flame sensors, limit switches and boards. Cracked heat exchangers are replaced, not repaired — see heating installation.
Do you charge more for cold-snap emergency calls?
No. Flat $89 diagnostic and the same repair prices 24/7, including the two or three nights a year Orlando drops below 40°F.
Why is heating so expensive on my power bill?
If your heat pump is running on emergency heat, or the strips are stuck on, you're paying for resistance heat at two to three times the cost. See what emergency heat does to your bill.
Get an Honest Heating Repair Quote — $89, Applied to Your Repair
5.0 stars, 120 Google reviews. Video-documented diagnostics. 90-minute arrival or $200 off. Same price 24/7.
Call (407) 465-7777Smart Home Air & Heat — 10226 Curry Ford Rd, Orlando, FL 32825 — [email protected]